6/29/2023 0 Comments Head liquid metal 4 reviewThere are lines that read, " Overclocking with AMD's Ryzen Master utility is simple. What I found instead were optimistic projections about the overclocking capability of that chip. I wanted to read more about the overclocking outcomes and limits in the 2400G launch article. I read the review for the Ryzen 2400G, but I guess I missed that detail. Intel CPUs are temperature limited, this one not. And the conclusion said: you get it cooler, but not faster. This is an AMD APU and we overclocked it also on the launch review to the stable maximum. Motherboard components are cooled by 22☌ air from a large fan blowing across them.įormatC said:Did you really read the launch review and this one? The barrier for a higher overclock is NOT the temperature. We combine it with the Alphacool Eisblock XPX, replacing AMD's Wraith Stealth heat sink. That's where Alphacool's powerful Eiszeit 2000 Chiller comes into play. In order to establish the limits of AMD's Raven Ridge-based processors, we need to push them as far as they can go. An hour should be more than sufficient to achieve production-ready performance, though silicone needs about a day to cure properly. After a short temperature check with monitoring software like HWiNFO64, being a burn-in process with Prime95 and be ready to keep an eye on its progress. Alternately tighten the screws crosswise, and make sure not to tilt or move the heat sink. Make sure to attach the heat spreader in its correct orientation.įor perfect pressing and drying, carefully put the processor back into the socket, apply a small dot of high-quality thermal paste, and assemble the boxed cooler carefully. Glue would be applied to both sides of the heat spreader, while silicone is only applied to the package. Keep in mind that the glue must fill a gap of ~0.2mm so the adhesive still safely connects both sides after curing. All-purpose glue isn't sufficient for keeping the head spreader in place, even if its packaging claims the contents are suitable for metal. Finally, the heat spreader is reattached and glued in place with either cyanoacrylate or silicone.
0 Comments
Leave a Reply. |